Skip to content
Air Cooling
Menu

Service

HVAC design and installation

Load calculation, system selection, and commissioned installation.

Overview

What this covers.

We size, specify and install comfort and process cooling systems against a measured heat-load survey, not a rule-of-thumb floor area. Every design is documented to the standard your building services engineer and insurer will expect.

  • Heat-gain and load calculations (CIBSE methodology)
  • Split, VRF/VRV and chilled-water system selection
  • Duct routing, pressure-drop and airflow balancing
  • Installation supervision and F-gas compliant commissioning
  • As-built drawings and O&M documentation

Delivery

How the work is delivered

  1. 01

    Site survey

    Measure envelope, internal gains, occupancy and existing plant.

  2. 02

    Load model

    Calculate peak and part-load demand; record assumptions.

  3. 03

    Specification

    Issue equipment schedule, layouts and performance targets.

  4. 04

    Installation

    Install under permit with weekly QA checkpoints.

  5. 05

    Commissioning

    Balance airflow, verify setpoints, hand over logs.

Specification

Key facts.

Design basis
CIBSE Guide A, measured survey data
Refrigerant compliance
F-gas Regulation (EU) 517/2014 / UK equivalent
Typical capacity range
2 kW to 1 MW per system
Handover pack
As-builts, test certificates, O&M manual

Questions

Common questions.

How do you decide what size system a building needs?
We run a heat-load calculation from a site survey covering fabric, glazing, internal gains and occupancy, then size for peak and part-load conditions rather than oversizing from floor area.
Do you provide commissioning certificates?
Yes. Each installation is commissioned with recorded airflow, refrigerant charge and setpoint verification, and the certificates are included in the handover pack.

Book a survey for hvac design and installation.

We'll confirm scope, what we need to measure and the cost of the survey before any site visit.